Page 1 of 1

Adding contour to a part from site

Posted: Sat Jul 18, 2020 12:30 pm
by Hala Mohamed
Hello,

This is my site on monde and it is all flat except the highlighted area. so is it possible to add contour only to the highlighted area? as when I tried to add topography to the whole site, there were variations in the contour for the whole site which is not the case.
AG Map.jpg
.

Thanks.

Re: Adding contour to a part from site

Posted: Sun Jul 19, 2020 12:39 pm
by Tim
Hi,

I don't see any highlighted area. However, if you want to simulate with terrain data, it makes sense to model the terrain correctly for the whole model area and not only for a certain area of interest. If there are only small differences in height, I would recommend to not use terrain at all, since it makes things much more complicated without bringing much use.
If you think that the terrain imported by Monde is not correct for the site at all, the coordinates of the imported shapefiles could be incorrect leading to a wrong location and thus to terrain data of a totally different site.

Best regards,
Tim